Configuring the SPB-PIM Gateway brouter port optional parameters

Configure the SPB-PIM Gateway interface parameters on a brouter port.

Procedure

Enter GigabitEthernet Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the SPB-PIM Gateway brouter port HELLO interval:

ip spb-pim-gw hello-interval <0-18724>
Configure the SPB-PIM Gateway brouter port JOIN PRUNE interval:

ip spb-pim-gw join-prune-interval <1-18724>

The following table defines parameters for the ip spb-pim-gw command.


Variable	Value
hello-interval`<0-18724>`	Specifies the HELLO interval in seconds. The default value is 30 seconds.
join-prune-interval`<1-18724>`	Specifies the JOIN PRUNE interval in seconds. The default value is 60 seconds.