Configuring static MAC addresses for a VLAN
Configure the static MAC address parameters.
Procedure
Example
Configure a static MAC address of a VLAN:
Switch(config)# vlan mac-address-static 1 0x00:0x00:0x00:0x00:0x00:0x01 1/1
Variable Definitions
Use the data in the following table to use the vlan mac-address-static command.
|
Variable |
Value |
|---|---|
|
<1-4059> |
Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. |
|
<0x00:0x00:0x00:0x00:0x00:0x00> |
Indicates the MAC address. |
|
{slot/port[/sub-port][-slot/port[/sub-port]][,...]} |
Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port. |