Configuring link LSA suppression

About this task

Use the following procedure to configure link LSA suppression on a port or a VLAN, to decrease unnecessary link LSA generation and flooding for non-broadcast and non-NBMA interface.

Procedure

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Enter the following command:

ipv6 ospf area {A.B.C.D} network {p2p | p2mp} link-lsa-suppression

Example

Variable definitions

Following table describes the variables to the ipv6 ospf area {A.B.C.D} network p2p link-lsa-suppression command.


Variable	Description
`area {A.B.C.D}`	Create an IPv6 OSPF area.
`network`	Sets the type of interface.
`[eth\|NBMA\|p2mp\|p2p\|passive]`	Specifies the type of interface.
`link-lsa-suppression`	Enables link LSA suppression.