Configure EAP auto-isid-offset

Before you begin

Enable EAP globally or on the port.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure an I-SID offset value:

eapol auto-isid-offset <0-15995903>
Enable EAP globally:

eapol enable
Confirm that your configuration is correct:

show eapol system

Examples

Configure an I-SID offset value and enable I-SID offset globally on the switch:

Switch:1> enable
Switch:1#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch:1(config)#eapol auto-isid-offset 1000 
Switch:1(config)#eapol enable

View the current device configuration:

Switch:1>show eapol system
================================================================================
                                  Eapol System
================================================================================
                     eap : disabled
           Eapol Version : 3
         non-eap-pwd-fmt : mac-addr
     non-eap-pwd-fmt key : ******
 non-eap-pwd-fmt padding : disabled
 auto-isid-offset status : disabled
 auto-isid-offset value  : 1000

Variable Definitions

The following table defines parameters for the eapol auto-isid-offset command.


Variable	Value
`<0-15995903>`	Specifies the auto I-SID offset value. The default is 15995903.
enable	Enables auto I-SID offset. The default is disabled.