Configuring the MLD robustness

About this task

The robustness value allows the tuning for the expected packet loss on a link. If a link expects packet loss, increase the robustness variable value.

Procedure

  1. Enter Interface Configuration mode:

    enable

    configure terminal

    interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

    Note

    Note

    If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

  2. Configure the MLD robustness:

    ipv6 mld robust-value <2-255>

  3. Set the MLD robustness to its default value:

    default ipv6 mld robust-value

Variable Definitions

The following table describes the variables for the ipv6 mld robust-value command.

Variable Value

<2–255>

Specifies a numerical value for MLD snooping robustness.
9037469-00 Rev AB