Configuring interVRF route redistribution for RIP

Configure a redistribute entry to announce certain routes into the RIP domain, including static routes, direct routes, RIP, OSPF, IS-IS, or BGP. Use a route policy to control the redistribution of routes.

Before you begin

Enable RIP globally.
Configure a route policy.
Configure the VRFs.

Procedure

Enter VRF Router Configuration mode for a specific VRF context:

enable

configure terminal

router vrf WORD<1-16>
Create the redistribution instance:

ip rip redistribute <bgp|direct|isis|ospf|rip|static>
Apply a route policy, if required:

ip rip redistribute <bgp|direct|isis|ospf|rip|static> route-map WORD<0-64> [vrf-src WORD<1-16>]
Configure other parameters.
Enable the redistribution:

ip rip redistribute <bgp|direct|isis|ospf|rip|static> enable [vrf-src WORD<1-16>]
Ensure that the configuration is correct:

show ip rip redistribute [vrf WORD<1-16>] [vrfids WORD<1-512>]
Exit to Global Configuration mode:

exit
Apply the redistribution:

ip rip apply redistribute <bgp|direct|isis|ospf|rip|static> [vrf WORD<1-16>] [vrf-src WORD<1-16>]

Example

Create the redistribution instance, apply a route policy, enable the redistribution, and apply the redistribution.

Switch:1>enable
Switch:1#configure terminal
Switch:1#router vrf red
Switch:1(router-vrf)#ip rip redistribute ospf
Switch:1(router-vrf)#ip rip redistribute ospf route-map test1
Switch:1(router-vrf)#ip rip redistribute ospf enable
Switch:1(router-vrf)#exit
Switch:1(config)#ip rip apply redistribute ospf

Variable definitions


Variable	Value
`<bgp\|direct\|isis\|ospf\|rip\|static>`	Specifies the type of routes to redistribute (the protocol source). Valid options are bgp, isis, direct, rip, ospf, or static.
vrf-src `WORD<1-16>`	Specifies the source VRF instance. You do not need to configure this parameter for redistribution within the same VRF.
metric `<0-65535>`	Configures the metric to apply to redistributed routes.
route-map `WORD<0-64>`	Configures the route policy to apply to redistributed routes.

The following table defines parameters for the show ip rip redistribute command.


Variable	Value
vrf `WORD<1-16>`	Specifies the VRF instance.
vrfids `WORD<1-512>`	Specifies a range of VRF IDs.

The following table defines parameters for the ip rip apply redistribute command.


Variable	Value
vrf `WORD<1-16>`	Specifies the VRF instance.
vrf-src `WORD<1-16>`	Specifies the source VRF instance. You do not need to configure this parameter for redistribution within the same VRF.
`<bgp\|direct\|isis\|ospf\|rip\|static>`	Specifies the type of routes to redistribute (the protocol source). Valid options are bgp, isis, direct, rip, ospf, or static.