Configuring an ACE Ethernet source address

Perform this procedure to filter on specific Ethernet source addresses.

Before you begin

  • The ACL exists.

  • The ACE exists.

Procedure

  1. In the navigation tree, expand the following folders: Configuration > Security > Data Path.
  2. Click Advanced Filters (ACE/ACLs).
  3. Click the ACL tab.
  4. Select the appropriate ACL.
  5. Click ACE.
  6. Select the appropriate ACE.
  7. Click Eth.
  8. Click the Source Address tab.
  9. Click Insert.
  10. Specify the ACE Ethernet operation.
  11. In the List dialog box, specify the Ethernet source address.
  12. Click Insert.

Source Address Field Descriptions

Use the data in the following table to use the Source Address tab.

Variable

Value

AclId

Specifies the ACL ID.

AceId

Specifies the ACE ID.

Oper

The eq and mask parameters specify an operator for a field match condition: equal to or mask. The mask operator is an implied eq on the mask bits.

List

Specifies the MAC address to match.

OperMask

Specifies the MAC Address mask value in hexadecimal format. The value for this variable is empty or 000000000000 if the Oper variable is eq.
9037469-00 Rev AB