Configure the IPFIX Aging Interval

About this task

Use the following procedure to configure an aging interval for IPFIX. The aging interval determines how long a traffic flow that is no longer being received, is retained as a flow.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure a value for the aging interval:

ip ipfix aging-interval <100ms | 1s | 10s | 60s | 10m | 30m | 1h |10h |1d>
Configure a value for the aging interval:

ip ipfix aging-interval <1-60>

Example

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#ip ipfix aging-interval 1d

Variable Definitions

The following table defines parameters for the ip ipfix aging-interval command.


Variable	Value
<100ms \| 1s \| 10s \| 60s \| 10m \| 30m \| 1h \|10h \|1d>	Specifies (in seconds, minutes, hours, or days) the flow record aging interval. The aging interval determines how long a traffic flow that is no longer being received is retained as a flow. The default is 10 seconds.