Viewing SBT entries

About this task

Use this procedure to view SBT entries.

Procedure

  1. Enter Privileged EXEC mode:

    enable

  2. View all SBT entries:

    show ipv6 fhs snooping binding

  3. View the SBT entries by type:

    show ipv6 fhs snooping binding type {dynamic | static}

  4. View the SBT entries by VLAN:

    show ipv6 fhs snooping binding vlan <1-4059>[ipv6-address WORD<0-46>]

Variable Definitions

The following table defines parameters for the show ipv6 fhs snooping binding command.

Variable

Value

ipv6-address WORD<0-46>

Specifies the IPv6 address for the binding entry.

type {dynamic | static}

Shows only dynamic binding entries or static binding entries.

vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

9037469-00 Rev AB