Display IKE V2 Security Association
Use the following procedure to view the IKE version 2 security association.
Procedure
- In the navigation pane, expand .
- Click IKE.
- Click the V2 SA tab.
V2 SA field descriptions
Use the data in the following table to use the tab.
|
Name |
Description |
|---|---|
|
Id |
Specifies the profile ID. |
|
LocalIfIndex |
Specifies the Interface Index of the local address. Only port and vlan interfaces are supported. |
|
LocalAddrType |
Specifies whether the local address is an IPv4 or IPv6 address. |
|
LocalAddr |
Specifies the address of the local peer. |
|
RemoteAddrType |
Specifies whether the remote address is an IPv4 or IPv6 address. |
|
RemoteAddr |
Specifies the address of the remote peer. |
|
Name |
Specifies the name given to the SA. |
|
AuthenticationMethod |
Specifies the proposed authentication method for theVersion 2 security association. The default authentication method is pre-shared key. |
|
DPDTimeout |
Specifies the Dead Peer Detection timeout in seconds. |
|
HashAlgorithm |
Specifies the hash algorithm negotiated for this IKE Version 2 SA. |
|
EncryptionAlgorithm |
Specifies the encryption algorithm negotiated for this IKE Version 2 SA. |
|
EncryptKeyLen |
Specifies the encryption key length negotiated for this IKE Version 2 SA. |
|
DHGroup |
Specifies the Diffie-Hellman group negotiated for this IKE Version 2 SA. |
|
ExchangeMode |
Specifies the IKE Version 2 SA mode. |
|
LifetimeSeconds |
Specifies the amount of time for which an IKE Version 2 SA can remain valid during IKE Version 2 negotiation. A value of 0 means no the SA always remains valid. |
|
Status |
Specifies whether the SA is active or inactive. |
|
Initiator |
Specifies whether specifies the whether the SA is created by an initiator or a responder. |
|
IntegrityAlgorithm |
Specifies the type of integrity algorithm. |