Configuring the MLD last listener query interval

About this task

Use this procedure to configure the last listener query interval in seconds for the MLD interface.

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the last listener query interval:

ipv6 mld last-listener-query-interval <0-60>
Set the last listener query interval to its default value:

default ipv6 mld last-listener-query-interval

The following table describes the variables for the ipv6 mld last-listener-query-interval command.


Variable	Value
<0–60>	Indicates the last listener query interval in seconds.