Configuring the MLD query interval

About this task

Use this procedure to configure the query interval for the MLD interface.

Enter Interface Configuration mode:

enable

configure terminal

interface GigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]} or interface vlan <1–4059>

Note

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
Configure the query interval for the MLD interface:

ipv6 mld query-interval <1-65535>
Set the query interval to its default value:

default ipv6 mld query-interval

The following table describes the variables for the ipv6 mld query-interval command.


Variable	Value
`<1-65535>`	Indicates the frequency at which MLD host query packets transmit on this interface.