Enable IPsec on an IPv4 Interface

Use the following procedure to enable IPsec on an IPv4 interface.

Note

Note

If you downgrade your software, the current IPsec configurations are no longer supported. You must boot with the factory default settings for IPsec, and then reconfigure the IPsec features.

Procedure

  1. In the navigation pane, expand Configuration > Security > Control Path.
  2. Click IPSec.
  3. Click the IPv4 Interfaces tab.
  4. In the IpsecEnable column, double-click in the IpsecEnable field, and select enable from the drop-down box.
  5. Click Apply.

IPv4 Interfaces tab field descriptions

Use the data in the following table to use the IPv4 Interfaces tab.

Name

Description

Interface

Specifies the interface.

IpsecEnable

Specifies if IPsec is enabled on that particular interface.
9037469-00 Rev AB