Viewing Layer 3 VSN information
About this task
View VRFs corresponding to Layer 3 (routed) VSN I-SIDs on either a Controller or a Leaf node.
Before you begin
Ensure that you enable DvR globally on the node.
Procedure
Example
View Layer 3 VSN information on a DvR Controller:
Switch:1#show dvr l3vsn
====================================================================
DVR L3VSN
====================================================================
VRF ID L3VSN ISID VRF NAME INJECT-DEFAULT-ROUTE-DISABLE
--------------------------------------------------------------------
1 55500 vrf600 Disabled
2 55501 vrf601 Disabled
3 55502 vrf602 Disabled
4 55503 vrf603 Disabled
4 out of 4 Total Num of DVR L3VSN displayed
---------------------------------------------------------------------
View Layer 3 VSN information on a DvR Leaf node:
Switch2:1#show dvr l3vsn
====================================================================
DVR L3VSN
====================================================================
VRF ID L3VSN ISID VRF NAME
--------------------------------------------------------------------
1 55500 vrf600
2 55501 vrf601
3 55502 vrf602
3 out of 3 Total Num of DVR L3VSN displayed
---------------------------------------------------------------------
Variable definitions
Use the data in the following table to use the show dvr l3vsn command.
|
Variable |
Value |
|---|---|
|
l3isid <0-16777215> |
Specifies the Layer 3 VSN I-SID. The range is 0 to 16777215. |
|
vrf WORD<1-16> |
Specifies the VRF name of the VRF corresponding to the Layer 3 VSN I-SID. |
|
vrfids WORD<0-512> |
Specifies the VRF ID of the VRF. |