Configuring a static foreign source on the global router

Configure a static foreign source on the global router. Configuration is done at the Controller. Statically configure foreign sources, such as streams in a Source Specific Multicast (SSM) group range that are not advertised by the foreign network through MSDP. Non-SSM range group multicast address streams are advertised by MSDP and do not need to be statically configured.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure a static foreign source:

ip spb-pim-gw foreign-source {A.B.C.D} group {A.B.C.D}

Example

Switch:1>enable

Switch:1#configure terminal

Switch:1(config)#ip spb-pim-gw foreign-source 10.0.0.1 group 240.0.0.1

Variable definitions

The following table defines parameters for the ip spb-pim-gw command.


Variable	Value
foreign-source`{A.B.C.D}`	Specifies the multicast foreign source IP address.
group`{A.B.C.D}`	Specifies the group IP address.