Configuring SSH rekey time-interval

Use the following procedure to configure a time interval, after which the key exchange takes place.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enter the following command:

    ssh rekey time-interval <1–6>

Example

Switch:1> enable
Switch:1# configure terminal

Configure the SSH rekey time-interval to 3 hours:

Switch:1(config)# ssh rekey time-interval 3

Variable Definitions

The following table defines parameters for thessh rekey time-interval command.

Variable

Value

<1–6>

Sets the time-interval for SSH rekeying in hours, the range is 1 to 6.
9037469-00 Rev AB