Configuring a candidate bootstrap router

Configure routers as candidate bootstrap routers (C-BSR) to provide backup protection in case the primary BSR fails. PIM-SM cannot operate without a BSR. A PIM-SM domain can use only one active BSR.

About this task

The C-BSR with the highest configured priority becomes the BSR for the domain. If two C-BSRs use equal priority, the candidate with the higher IP address becomes the BSR. If you add a new C-BSR with a higher priority to the domain, it automatically becomes the new BSR.

Procedure

  1. On the Device Physical View tab, select a port.
  2. In the navigation pane, expand the following folders: Configuration > Edit > Port.
  3. Click IP.
  4. Click the PIM tab.
  5. Click Enable.
  6. In the CBSRPreference box, type the preference.

    The C-BSR with the highest BSR-preference and address becomes the active BSR. The default is –1, which indicates that the current interface is not a C-BSR.

  7. Click Apply.
9037469-00 Rev AB