Configure ACE Actions to Mirror

Configure actions to use filters for flow-based mirroring.

Before you begin

If you use the mirror action, ensure that you specify the mirroring destination: MLTs or ports.

Enter Global Configuration mode:

enable

configure terminal
Configure actions for an ACE:

filter acl ace action <1-2048> <1-2000> {permit|deny} monitor-dst-mlt <1–512>

OR

filter acl ace action <1-2048> <1-2000> {permit|deny} monitor-dst-ports {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
Ensure the configuration is correct:

show filter acl action [<1-2048>] [<1-2000>]

Switch:1> enable

Switch:1# configure terminal

Switch:1(config)# filter acl ace action 901 1 permit monitor-dst-mlt 5

The following table defines parameters for the filter acl ace action command.


Variable	Value
`1-2048`	Specifies the ACL ID from 1–2048
`1-2000`	Specifies the ACE ID from 1–2000.
monitor-dst-mlt `<1–512>`	Configures mirroring to a destination MLT group.
monitor-dst-ports `{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}`	Configures mirroring to a destination port or ports.
{permit\|deny}	Configures the action mode for security ACEs. The default value is permit.