About this task
Perform this procedure to enable Auto-sense on one or more ports.
If you select more than one port, the format of the tab changes to a table-based
tab.
Note
- After a switch boots without a configuration file, Auto-sense is enabled on all
ports, by default.
- Auto-sense is disabled by default for existing configurations but enabled for new
Zero Touch Fabric Configuration deployments.
- Auto-Sense cannot be enabled when the spbm-config-mode flag is false.
Procedure
-
In the Device
Physical View tab, select one or more ports.
-
In the navigation pane, expand
.
-
Select General.
-
Select the Interface tab.
-
For AutoSense, select
enable.
-
Select Apply.
