ip ecmp
Enable Equal Cost Multipath protocol (ECMP). If the ECMP parameter is disabled, all
existing ECMP routes are removed. When ECMP is enabled, all ECMP routes are re-added.
Syntax
-
default ip ecmp
-
default ip ecmp
-
default ip ecmp max-path
-
ip ecmp
-
ip ecmp max-path <ECMP-Paths>
-
ip ecmp pathlist-1
WORD<0-64>
-
ip ecmp pathlist-2
WORD<0-64>
-
ip ecmp pathlist-3
WORD<0-64>
-
ip ecmp pathlist-4
WORD<0-64>
-
ip ecmp pathlist-5
WORD<0-64>
-
ip ecmp pathlist-6
WORD<0-64>
-
ip ecmp pathlist-7
WORD<0-64>
-
ip ecmp pathlist-8
WORD<0-64>
-
no ip ecmp
-
no ip ecmp pathlist-1
-
no ip ecmp pathlist-2
-
no ip ecmp pathlist-3
-
no ip ecmp pathlist-4
-
no ip ecmp pathlist-5
-
no ip ecmp pathlist-6
-
no ip ecmp pathlist-7
-
no ip ecmp pathlist-8
Command Parameters
- max-path <ECMP-Paths>
-
Specifies the maximum number of ECMP paths. Different
hardware platforms can support a different number of ECMP paths. For more
information on the maximum number of ECMP paths supported on the switch, see the
scaling information in VSP 8600 Release Notes.
- pathlist-1 WORD<0-64>
- Configures one equal-cost path to
the same destination prefix. To remove the policy, enter a blank string. To
configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-2 WORD<0-64>
- Configures up to two equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-3 WORD<0-64>
- Configures up to three equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-4 WORD<0-64>
- Configures up to four equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-5 WORD<0-64>
- Configures up to five equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-6 WORD<0-64>
- Configures up to six equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-7 WORD<0-64>
- Configures up to seven equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
- pathlist-8 WORD<0-64>
- Configures up to eight equal-cost
paths to the same destination prefix. To remove the policy, enter a blank string.
To configure this parameter, you must globally enable Equal Cost Multipath
(ECMP).
Default
The default is disabled.
Command Mode
Global Configuration
