ip vrf

Syntax

• default ip vrf WORD<1-16> max-routes

• default ip vrf WORD<1-16> max-routes-trap enable

• default ip vrf WORD<1-16> vrf-trap enable

• ip vrf WORD<1-16>

• ip vrf WORD<1-16> ipv6-max-routes <max-routes>

• ip vrf WORD<1-16> ipv6-max-routes-trap enable

• ip vrf WORD<1-16> max-routes <max-routes>

• ip vrf WORD<1-16> max-routes-trap enable

• ip vrf WORD<1-16> name WORD<0-16>

• ip vrf WORD<1-16> vrfid <1-511>

• ip vrf WORD<1-16> vrf-trap enable

• no ip vrf WORD<1-16>

• no ip vrf WORD<1-16> ipv6-max-routes-trap enable

• no ip vrf WORD<1-16> max-routes-trap enable

• no ip vrf WORD<1-16> vrf-trap enable

Command Parameters

ipv6-max-routes <0-7744>

Specifies the maximum number of IPv6 routes for the VRF. Depending on the hardware platform, the parameter range and default value can vary. Use the CLI Help to see the available range for the switch. For route scaling information, see VSP 8600 Release Notes.

ipv6-max-routes-trap enable

Enables SNMP trap generation based on the configured number of maximum IPv6 routes.

max-routes <max-routes>

Specifies the maximum number of IPv4 routes for the VRF. Depending on the hardware platform, the parameter range and default value can vary. Use the CLI Help to see the available range for the switch. For route scaling information, see VSP 8600 Release Notes.

max-routes-trap enable

Enables the sending of traps after the maximum number of routes is reached. The default is enabled.

name WORD<1-16>

Renames the VRF instance.

vrfid <1-511>

Specifies a VRF ID. The switch supports 512 VRFs.

vrf-trap enable

Enables the device to send VRF-related traps. The default is enabled.

WORD<1-16>

Specifies the name for the VRF.

Default

None

Command Mode

Global Configuration