vlacp

Configure Virtual Link Aggregation Control Protocol (VLACP) on a port to ensure that there is end-to-end reachability.

Syntax

Command Parameters

enable
Enables VLACP for this port.
ethertype <0X600-0Xffff>
Configures the VLACP protocol identification for this port.
fast-periodic-time <100-20000>
Configures the fast periodic time (in milliseconds) for this port.
flap-frequency <3-30>
Configures the frequency of VLACP flaps allowed in a specific time interval for the VLACP Flap Detect and Damping feature. The default value is 3.
flap-interval <10-600>
Configures the time interval (in seconds) to record the VLACP flaps on ports. The default value is 60 seconds.
funcmac-addr <0x00:0x00:0x00:0x00:0x00:0x00>
Configures the multicast MAC address used for the VLACPDU. Specify a MAC address in the format 0x00:0x00:0x00:0x00:0x00:0x00. The default is 01:80:c2:00:11:00.
slow-periodic-time <10000-30000>
Configures the slow periodic time (in milliseconds) for a specific port type.
timeout {long|short}
Configures the port to use the long or short timeout:

  • Long configures the port to use the timeout-scale value multiplied by the slow-periodic-time.

  • Short configures the port to use the timeout-scale value multiplied by the fast-periodic-time.

For example, if you specify a short timeout, configure the timeout-scale value to 3, and the fast-periodic-time to 400 ms, the timer will expire within 1000 to 1200 ms. To configure this option to the default value, use the default operator with the command.
timeout-scale <2-10>
Configures a timeout scale for this port used to calculate the timeout. The default value is 3. To configure this option to the default value, use the default operator with the command.

Default

None

Command Mode

GigabitEthernet Interface Configuration

Usage Guidelines

Use the following information to prevent flooding VLACP packets across a defaulted switch:

9037144-00 Rev AA