mgmt dhcp-client

Syntax

• mgmt dhcp-client {cycle | oob | vlan}

• no mgmt dhcp-client

Command Parameters

cycle

Specifies the DHCP Client to attempt to obtain an IP address on the In-Band VLAN management interface, then the Out-of-Band management interface. Cycle attempts until an IP address is obtained.

oob

Specifies the DHCP Client to obtain an IP address for the Out-of-Band management interface.

vlan

Specifies the DHCP Client to obtain an IP address for the In-Band VLAN management interface.

Default

The DHCP Client for management interfaces is disabled.

Note

Exception: the DHCP Client is enabled by default in cycle mode when:

• The switch ships directly from manufacturing with VOSS Release 8.1.60 or later.

  The primary and secondary configuration file is not on the switch.

  The primary and secondary configuration file fail to load on the switch.

Command Mode

Global Configuration

Usage Guidelines

This command is not supported on VSP 8600 Series. For more information about feature support, see VOSS Feature Support Matrix.