show sys setting

Shows system settings.

Syntax

show sys setting

Default

None

Command Mode

User EXEC

Usage Guidelines

The default-ping-context field is not supported on VSP 8600 Series.

Command Output

The show sys setting command displays the following information:


Output field	Description
udp-checksum	Displays if the User Datagram Protocol (UDP) checksum calculation is enabled.
mroute-stream-limit	Displays if Mroute stream limit is enabled.
contact	Displays the system contact.
location	Displays the system location.
name	Displays the system name.
portlock	Displays if port lock is enabled.
sendAuthenticationTrap	Displays if the system sends the authentication success trap.
autotopology	Displays if SynOptics Network Management Protocol (SONMP) is enabled.
mtu	Displays the system maximum transmission unit (MTU).
prototype	Displays if prototype is enabled.
data-path-fault-shutdown	Displays if data path fault shutdown is enabled.
secure-console	Displays if secure console access is enabled.
default-ping-context	Displays the default context in which you run ping and traceroute commands.

Example

The following example displays output from the show sys setting command.

Switch:1#show sys setting

	          udp-checksum : enable
	   mroute-stream-limit : disable
		        contact : http://www.company.com/
		       location : Anywhere, USA
		           name : Switch
		       portlock : off
	sendAuthenticationTrap : false
		   autotopology : on
	       	     mtu : 1950
		      prototype : disable
     data-path-fault-shutdown : enable
	        secure-console : disable
	  default-ping-context : grt