Displays the DvR interfaces on either a Controller or a Leaf node. On Controllers, DvR interfaces are created when you configure IP on a DvR enabled Layer 2 VSN (VLAN, I-SID). Only Controllers display the administrative state of the interfaces because this is where you enable or disable the interfaces. The Leaf nodes display DvR interface information that is pushed from the Controllers, for example, subnet routes or gateway IP addresses for the Layer 2 VSNs.
show dvr interfaces
show dvr interfaces l3isid <0-16777215>
show dvr interfaces vrf WORD<1-16>
show dvr interfaces vrfids WORD<0-512>
none
User EXEC
The show dvr interfaces command displays the following information:
|
Output field |
Description |
|---|---|
|
Interface |
Specifies the VLAN IP address (IPv4) of the DvR interface. |
|
Mask |
Specifies the subnet mask of the VLAN IP address. |
|
L3ISID |
Specifies the Layer 3 I-SID of the DvR interface. The range is 0 to 16777215. |
|
VRFID |
Specifies the VRF ID of the DvR interface |
|
L2ISID |
Specifies the Layer 2 I-SID of the DvR interface. The range is 1 to 16777215. |
|
VLAN |
Specifies the VLAN ID of the DvR interface. |
|
GW IPv4 |
Specifies the DvR gateway IP address (IPv4). |
|
Admin State |
Specifies the administrative state of the DvR interface. Note:
This field displays only on a Controller node. |
|
SPBMC State |
Specifies the SBPMC state of the DvR interface. |
|
IGMP version |
Specifies the version of IGMP running on the DvR interface. |