clear ipv6 statistics

Syntax

• clear ipv6 statistics all [vrf WORD<1-16> | vrfids WORD<0-512>]

• clear ipv6 statistics interface [vrf WORD<1-16> | vrfids WORD<0-512>]

• clear ipv6 statistics interface general [vrf WORD<1-16> | vrfids WORD<0-512>]

• clear ipv6 statistics interface general gigabitethernet {slot/port[/sub-port]} [vrf WORD<1-16> | vrfids WORD<0-512>]

• clear ipv6 statistics interface general loopback <1-256>

• clear ipv6 statistics interface general mgmtethernet mgmt

• clear ipv6 statistics interface general tunnel <1-2000>

• clear ipv6 statistics interface general vlan <1-4059>

• clear ipv6 statistics interface icmp

• clear ipv6 statistics interface icmp gigabitethernet {slot/port[/sub-port]}

• clear ipv6 statistics interface icmp loopback <1-256>

• clear ipv6 statistics interface icmp mgmtethernet mgmt

• clear ipv6 statistics interface icmp tunnel <1-2000>

• clear ipv6 statistics interface icmp vlan <1-4059>

• clear ipv6 statistics tcp [vrf WORD<1-16> | vrfids WORD<0-512>]

• clear ipv6 statistics udp [vrf WORD<1-16> | vrfids WORD<0-512>]

Command Parameters

all

Clears all statistics.

general

Clears general statistics.

gigabitEthernet {slot/port[/sub-port]}

Clears statistics for a brouter interface.

Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

icmp

Clears Internet Control Message Protocol (ICMP) statistics.

loopback <1-256>

Identifies a loopback interface.

mgmtethernet mgmt

Clears statistics for a management port.

tcp

Clears TCP statistics.

tunnel <1-2000>

Clears statistics for a tunnel.

udp

Clears UDP statistics.

vlan <1-4059>

Clears statistics for a tunnel.

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf WORD<1-16>

Clears the interface information for a particular VRF name.

vrfids WORD<0-512>

Clears the interface information for the particular VRF ids

Default

None

Command Mode

Privileged EXEC

Usage Guidelines

The mgmtethernet mgmt parameter only applies to VSP 8600 Series.