show ipv6 neighbor

Syntax

• show ipv6 neighbor

• show ipv6 neighbor interface gigbitethernet {slot/port[sub-port]}

• show ipv6 neighbor interface mgmtEthernet

• show ipv6 neighbor interface mgmtEthernet mgmt

• show ipv6 neighbor interface mlt <1-512>

• show ipv6 neighbor interface mlt <1-512> vrf WORD<1-16>

• show ipv6 neighbor interface mlt <1-512> vrfids WORD<0-512>

• show ipv6 neighbor interface vlan <1-4059>

• show ipv6 neighbor type <1-4>

• show ipv6 neighbor type <1-4> vrf WORD<1-16>

• show ipv6 neighbor type <1-4> vrfids WORD<0-512>

• show ipv6 neighbor vrf WORD<1-16>

• show ipv6 neighbor vrfids WORD<0-512>

• show ipv6 neighbor WORD<0-46>

• show ipv6 neighbor WORD<0-46> vrf WORD<1-16>

• show ipv6 neighbor WORD<0-46> vrfids WORD<0-512>

Command Parameters

{slot/port[sub-port]}

Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

<1-512>

Specifies the MLT ID.

mgmtEthernet [mgmt]

Displays neighbor entries for a management port.

type <1-4>

Specifies the type of mapping: 1: other, 2: dynamic, 3: static, or 4: local.

vlan <1-4059>

Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.

vrf WORD<1-16>

Specifies a VRF name. The VRF parameter is optional.

vrfids WORD<0-512>

Specifies a VRF by ID. The VRF parameter is optional.

WORD<0-46>

Specifies the neighbor address.

Default

None

Command Mode

User EXEC

Usage Guidelines

The mgmtethernet mgmt parameter only applies to VSP 8600 Series.