show ipv6 dcache

Display the destination cache to see next-hop addresses for destinations. The destination cache is only populated or updated when IPv6 packets originate locally on the central processor of the switch.

Syntax

show ipv6 dcache gigabitethernet {slot/port[sub-port]}
show ipv6 dcache mgmtethernet mgmt
show ipv6 dcache tunnel <1-2000>
show ipv6 dcache vlan <1-4059>
show ipv6 dcache vrf WORD<1-16>
show ipv6 dcache vrfids WORD<0-512>

Command Parameters

gigabitethernet {slot/port[sub-port]}: Identifies a single slot and port. If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
mgmtethernet mgmt: Identifies the management port.
tunnel <1-2000>: Specifies the tunnel ID.
vlan <1-4059>: Specifies the VLAN ID in the range of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1.
vrf WORD<1-16>: Specifies a VRF name. The VRF parameter is optional.
vrfids WORD<0-512>: Specifies a VRF by ID. The VRF parameter is optional.

Default

None

Command Mode

User EXEC

Usage Guidelines

The mgmtethernet mgmt parameter only applies to VSP 8600 Series.