convert (for a Management VLAN)

Syntax

• convert vlan <2-4059> [rollback <0-3600>] ​

• convert ip <A.B.C.D A.B.C.D | A.B.C.D/X>] [rollback <0-3600>]

• convert gateway <A.B.C.D> [rollback <0-3600>]

• convert i-sid <1-16777215> [rollback <0-3600>]

• convert vlan <2-4059> [ports-tagged {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] [rollback <0-3600>] ​

• convert vlan <2-4059> [ports-untagged {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] [rollback <0-3600>] ​

Command Parameters

<2-4059>

Specifies the VLAN ID in the range of 2 to 4059. VLAN ID 1 is the default VLAN and you cannot create or delete VLAN ID 1. By default, the system reserves VLAN IDs 4060 to 4094 for internal use. On switches that support the vrf-scaling and spbm-config-mode boot configuration flags, if you enable these flags, the system also reserves VLAN IDs 3500 to 3998.

<A.B.C.D A.B.C.D | A.B.C.D/X>

Specifies the IP address and subnet mask.

<A.B.C.D>

Specifies the gateway IP address.

<1-16777215>

Specifies the service instance identifier (I-SID).

<0-3600>

Specifies the time in seconds between when the command is issued and when the command changes will be undone. The default is 120 seconds. To disable the rollback, enter 0.

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

None

Command Mode

Management Instance Configuration

Usage Guidelines

This command is not supported on VSP 8600 Series.