speed

Configure the speed of the port on the Ethernet modules.

Note

Not all parameters appear on all hardware platforms.

Syntax

default speed
default speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
speed 10
speed 100
speed 1000
speed 10000
speed 2500
speed 25000
speed 5000
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 10
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 100
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 1000
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 10000
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 2500
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 25000
speed port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} 5000

Command Parameters

{slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}: Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
<10|100|1000|10000|2500|25000|5000>: Specifies the port speed.

Default

None

Command Mode

GigabitEthernet Interface Configuration

Usage Guidelines

If Auto-Negotiation is disabled and you manually configure the speed on a port that results in a configuration mismatch in speed between two ports, VSP 4450 Series and VSP 4900 Series switches may show an incorrect operational status of "up" for the mismatched ports.