ip-tunnel-source-address

Syntax

• ip-tunnel-source-address {A.B.C.D} [port {slot/port[/sub-port][-slot/port[/sub-port]][,...]}] [vrf WORD<1–16>] [mtu <mtu_value>]

• ip-tunnel-source-address {A.B.C.D} port {slot/port[/sub-port][-slot/port[/sub-port]][,...]} mtu <mtu_value>

• ip-tunnel-source-address {A.B.C.D} mtu <mtu_value>

• ip-tunnel-source-address {A.B.C.D} vrf WORD<1–16>

• no ip-tunnel-source-address

Command Parameters

{A.B.C.D}

Specifies the IS-IS IPv4 tunnel source address.

port {slot/port[/sub-port] [-slot/port[/sub-port]] [,...]}

Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

vrf WORD<1-16>

Specifies the VRF name associated with the IP tunnel.

mtu

Specifies the Maximum Transmission Unit (MTU) size for each packet. Different hardware platforms support different MTU ranges. Use the CLI Help to see the available range for the switch.

Default

None

Command Mode

IS-IS Router Configuration