VOSS Command Line Interface Commands Reference

Syntax

show ip mroute interface
show ip mroute interface gigabitethernet
show ip mroute interface gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
show ip mroute interface vrf WORD<1-16>
show ip mroute interface vrf WORD<1-32>
show ip mroute interface vrfids WORD<0-255>
show ip mroute interface vrfids WORD<0-512>

Command Parameters

gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}: Identifies the slot and port in one of the following formats: a single slot and port (slot/port), a range of slots and ports (slot/port-slot/port), or a series of slots and ports (slot/port,slot/port,slot/port). If your platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.
vrf WORD<1-32> | vrf WORD<1-16>: Specifies a VRF by name. Range depends on hardware platform.
vrfids WORD <0-255> | vrfids WORD <0-512>: Specifies a VRF ID. Range depends on hardware platform.

Default

None

Command Mode

User EXEC

Usage Guidelines

This command is not supported on a node configured as the DvR Leaf within a DvR domain.

The following message displays if the system shuts down the port due to excessive multicast streams:

Shutdown port <port> due to excessive multicast streams <# of streams ingressed>; Configured limit max streams <configured limit> in <configured sampling interval> sec. Please disable and re-enable the port.

Command Output

The show ip mroute interface command displays the following information:


Output field	Description
INTERFACE	Indicates the interface.
TTL	Indicates the datagram TTL threshold for the interface. IP multicast datagrams with a TTL less than this threshold are not forwarded out of the interface. The default value of 0 means all multicast packets are forwarded out of the interface.
PROTOCOL	Indicates the routing protocol running on this interface.
PORT	Shows the slot and port location.
MROUTE STR LIMIT	Indicates the maximum number of multicast streams that can enter the CPU through this port.
MROUTE STR LIMIT TMR	Indicates the sampling period (in seconds) to check number of multicast streams that enter the CPU through this port.
ENABLE	Indicates the status of the mroute stream limit on the port.