ipv6 ospf area virtual-link (for a VRF)

Syntax

• default ipv6 area virtual-link {A.B.C.D} {A.B.C.D}

• default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} dead-interval

• default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} hello-interval

• default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} retransmit-interval

• default ipv6 area virtual-link {A.B.C.D} {A.B.C.D} transit-delay

• ipv6 area virtual-link {A.B.C.D} {A.B.C.D}

• ipv6 area virtual-link {A.B.C.D} {A.B.C.D} dead-interval <1-65535>

• ipv6 area virtual-link {A.B.C.D} {A.B.C.D} hello-interval <1-65535>

• ipv6 area virtual-link {A.B.C.D} {A.B.C.D} retransmit-interval <1-1800>

• ipv6 area virtual-link {A.B.C.D} {A.B.C.D} transit-delay <1-1800>

• no ipv6 area virtual-link {A.B.C.D} {A.B.C.D}

Command Parameters

{A.B.C.D} {A.B.C.D}

Specifies the area address and the virtual link address.

dead-interval <1-65535>

Specifies the dead interval, as the number of seconds to wait before determining the OSPF router is down. The default dead-interval is 60.

hello-interval <1-65535>

Specifies the hello interval, in seconds, for hello packets sent between switches for a virtual interface in an OSPF area. The default hello interval is 10.

retransmit-interval <1-1800>

Specifies the retransmit interval, in seconds, for link-state advertisements. The default retransmit-interval is 5.

transit-delay <1-1800>

Specifies the transit-delay interval, in seconds, required to transmit a link-state update packet over the virtual interface. The default transit-delay is 1.

Default

None

Command Mode

VRF Router Configuration