ACL Ports

Configure the ACL parameters (ACE) of each switch port. These parameters will affect frames received on a port unless the frame matches a specific ACE.


Object	Description
Port	The logical port for the settings contained in the same row.
Policy ID	Select the policy to apply to this port. Valid values are 0 – 255. The default value is 0.
Action	Select whether forwarding is permitted (“Permit”) or denied (“Deny”). The default value is Permit.
Rate Limiter ID	Select which rate limiter to apply on this port. The allowed values are Disabled or the values 1 through 16. The default value is Disabled.
Port Redirect	Select which port frames are redirected on. The allowed values are Disabled or a specific port number and it can't be set when action is permitted. The default value is Disabled.
Mirror	Specify the mirror operation of this port. The allowed values are: Enabled: Frames received on the port are mirrored. Disabled: Frames received on the port are not mirrored.   The default value is Disabled.
Logging	Specify the logging operation of this port. Notice that the logging message doesn't include the 4 bytes CRC. The allowed values are: Enabled: Frames received on the port are stored in the System Log.  Disabled: Frames received on the port are not logged. The default value is Disabled. Note: The logging feature only works when the packet length is less than 1518(without VLAN tags) and the System Log memory size and logging rate is limited.
Shutdown	Specify the port shut down operation of this port. The allowed values are: Enabled: If a frame is received on the port, the port will be disabled. Disabled: Port shut down is disabled. The default value is Disabled. Note: The shutdown feature only works when the packet length is less than 1518(without VLAN tags).
State	Specify the port state of this port. The allowed values are: Enabled: To reopen ports by changing the volatile port configuration of the ACL user module. Disabled: To close ports by changing the volatile port configuration of the ACL user module. The default value is Enabled.
Counter	Counts the number of frames that match this ACE.


Buttons
	Refresh the page immediately. Any non-committed changes will be lost.
	Clear the counters or dynamic entries.
	Save changes.
	Undo any changes and revert to previously saved values.