Configure Dynamic Peer on Tenant BGP

About this task

Procedure

  1. To configure BGP dynamic peer, run the following commands: 
    efa tenant service bgp peer create --name <peer-name> --tenant <tenant-name>
                 --ipv4-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit> 
                 --ipv6-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>

    Example

    efa tenant service bgp peer create --name bgpservice1 --tenant tenant1
                --ipv4-uc-dyn-nbr BL1-IP,VRF1:11.22.33.44/30,pg1,10
  2. To update BGP dynamic peer, run the following commands: 
    efa tenant service bgp peer update --name <peer-name> --tenant <tenant-name>
                --operation peer-add 
                --ipv4-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>
                --ipv6-uc-dyn-nbr <border-leaf-ip,vrf-name:listen-range,peer-group-name,listen-limit>

    Example

    efa tenant service bgp peer create --name bgpservice1 --tenant tenant1                             
                --operation peer-add –ipv4-uc-dyn-nbr BL1-IP,VRF1:11::22/127,pg1,20
9037624-00 RevAA