Use this information to understand LED patterns on your APs during registration with ExtremeCloud. To troubleshoot the AP itself, see the device-specific Installation Guide for details about the applicable LED patterns.
The following table shows the LED patterns and the associated status for ExtremeWireless APs when they are connected to cloud management.
Radio B/G LED (Left) | Radio A LED (Right) | Status LED | AP Detailed State |
---|---|---|---|
Off | Off | Blink green | Initialization: Power-on self test (POST) |
Blink green | Blink green | Initialization: Random delay | |
Blink red | Initialization: No Ethernet | ||
Solid green | Blink green | Initialization: Vulnerable period (not supported) | |
Blink red | Reset to factory defaults | ||
Blink green | Off | Blink green or orange | Network discovery: 802.1x authentication |
Blink red | Failed 802.1x authentication | ||
Blink green | Blink green or orange | Network discovery: DHCP | |
Blink red | Default IP address | ||
Solid green | Blink green or orange | Network discovery: discovery/connect | |
Blink red | Discovery failed | ||
|
|
Solid green | Connected |
The following table shows the LED patterns and the associated status for ExtremeWireless WiNG APs when they are connected to cloud management.
Task | 5 GHz Activity LED (Amber) | 2.4 GHz Activity LED (Green) |
---|---|---|
Unconfigured Radio | On | On |
Normal Operation |
|
|
Firmware Update | On | Off |
Locate AP Mode | LEDs blink in an alternating green, red and amber pattern using an irregular blink rate. This LED state in no way resembles normal operating conditions. | LEDs blink in an alternating green, red and amber pattern using an irregular blink rate. This LED state in no way resembles normal operating conditions. |