Displays Ethernet OAM information.
| port_list | Specifies the particular ports. |
| detail | Specifies that detailed information be displayed. |
N/A.
Use this command to display basic Ethernet OAM information for specified ports on the switch. If you do not specify the port(s), information for all ports is displayed.
Use the detail option for additional information.
When operating as a stack master, the switch can process this command for ports on supported platforms.
The following command displays basic Ethernet OAM information for all ports:
show ethernet oam
Following is sample output from the command:
switch # show ethernet oam ================================================= Port Flags Tx Cnt Rx Cnt Tx Err Rx Err ================================================= 1 E--u 2 2 0 0 2 ---u 0 0 0 0 3 E-Ru 2 2 0 0 4 ---u 0 0 0 0 5 EU-u 0 0 0 0 6 ---u 0 0 0 0 7 ---u 0 0 0 0 8 ---u 0 0 0 0 9 ---u 0 0 0 0 10 ---u 0 0 0 0 11 ---u 0 0 0 0 12 ---u 0 0 0 0 13 ---u 0 0 0 0 14 ---u 0 0 0 0 15 ---u 0 0 0 0 16 ---u 0 0 0 0 17 ---u 0 0 0 0 18 ---u 0 0 0 0 19 ---u 0 0 0 0 20 ---u 0 0 0 0 21 ---- 0 0 0 0 22 ---- 0 0 0 0 23 ---- 0 0 0 0 24 ---- 0 0 0 0 25 ---- 0 0 0 0 26 ---- 0 0 0 0 ---------------------------------------------------- Flags : (E) OAM Enabled, (U) OAM Operationally Up, (R) Remote Port Fault Exists, (u) Unidirectional OAM Supported
The following command displays detailed information for port 1:
show ethernet oam port 1 detail
Following is sample output from the command:
switch # show ethernet oam port 1 detail Port Number : 1 Admin Status : Enabled Unidirectional OAM : Supported Oper Status : Disabled Remote Fault : Not Exists Tx Pkts : 2527 Rx Pkts : 2550 Tx Error : 0 Rx Error : 0
This command was first available in ExtremeXOS 12.3.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.