Displays configuration information for one or more VLANs in the current VR context.
vlan_name | Specifies a VLAN name. |
tunnel_name | Specifies an IPv6 tunnel. |
N/A.
If no VLAN information is specified, then global IP configuration is displayed. Otherwise, specific VLAN information is displayed.
# show ipconfig Use Redirects : Disabled IpOption LSRR : Enabled IpOption SSRR : Enabled IpOption RR : Enabled IpOption TS : Enabled IpOption RA : Enabled Route Sharing : Disabled Originated Packets : Don't require ipforwarding IP Fwding into LSP : Disabled Max Shared Gateways : Current: 4 Configured: 4 Route Sharing Hash : XOR, Custom Method Ping Protection : Enabled for static routes Interval: 2 Misses: 3 IP Anycast MAC : 00:00:AB:BA:BA:BA IRDP: Advertisement Address: 255.255.255.255 Maximum Interval: 600 Minimum Interval: 450 Lifetime: 1800 Preference: 0 Interface IP Address Flags nSIA data2 200.0.0.1 /24 EUf---R-------- 0 inet 1.1.1.2 /24 EUf---R-------- 0 mytun 2.0.0.2 /24 EU----R-------- 0
The following example displays configuration information about tunnel "mytunnel" with TCP MSS adjustment configuration (lines 3 and 8) and MTU value of 1400 (line 3):
# show ipconfig mytunnel Router Interface on mytunnel is enabled and up. inet 2.0.0.1/24 broadcast 2.0.0.255 Mtu 1500 TCP-MSS 1360 Flags: BOOTP Host NO DirBcstHwFwd NO Fwd Bcast NO IgnoreBcast YES IP Fwding YES IPmc Fwd NO Multinetted VLAN NO IRDP Advert NO Send Redir YES VRRP NO Unicast RPF NO TCP Adjust MSS ON
This command was first available in ExtremeXOS 10.1.
The ipv4 keyword was added in ExtremeXOS 11.2.
This command changed to display information for the current VR context in ExtremeXOS 12.5.
Ping protection information added in ExtremeXOS 22.1.
Route sharing hashing algorithm (default or custom) added in ExtremeXOS 22.1.
The D (duplicate address detected on VLAN), t (tentative address), A (address mask reply enabled), M (send parameter problem enabled), P (send port unreachables enabled), T (time stamp reply enabled), u (send unreachables enabled), and X (send time exceeded enabled) flags were removed in ExtremeXOS 30.1.
IP anycast information was added in ExtremeXOS 30.6.
TCP MSS adjustment and IP MTU information were added in ExtremeXOS 31.6.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.