Configures the TACACS+ accounting server.
|primary||Configures the primary TACACS+ accounting server.|
|secondary||Configures the secondary TACACS+ accounting server.|
|ipaddress||The IP address of the TACACS+ accounting server being configured.|
|hostname||The host name of the TACACS+ accounting server being configured.|
|tcp_port||The TCP port to use to contact the TACACS+ server.|
|ipaddress||The IP address used by the switch to identify itself when communicating with the TACACS+ accounting server.|
|vr_name||Specifies the virtual router
on which the client IP is located.
Note: User-created VRs are supported only on the platforms listed for this feature in the Switch Engine 32.3 Feature License Requirements document.
Unconfigured. The default virtual router is VR-Mgmt, the management virtual router.
You can use the same TACACS+ server for accounting and authentication.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
The following command configures server tacacs1 as the primary TACACS+ accounting server for client switch 10.10.20.35 using a virtual router interface of VR-Default:
configure tacacs-accounting primary server tacacs1 client-ip 10.10.20.35 vr vr-Default
This command was first available in ExtremeXOS 10.1.
This command is available on ExtremeSwitching 5320, 5420, 5520, and 5720 series switches.