This command allows you to add or remove remote VTEPs to a MAC address.
| mac_addr | Forwarding destination(s) for this MAC. |
| broadcast | Forwarding destination(s) for broadcast traffic. |
| unknown-unicast | Forwarding destination(s) for unknown unicast traffic. |
| unknown-multicast | Forwarding destination(s) for unknown multicast traffic. |
| add | Add to configuration. |
| delete | Delete from configuration. |
| vr | VR/VRF instance the IPv4 address is configured on. |
| vr_name | An existing VR/VRF name. |
| ipaddress | Configure the IP address of the remote tunnel endpoint to which the MAC needs to be bound. |
| remote_ipaddress | IPv4 address of the remote tunnel endpoint. |
VR-Default.
You must first use the [create | delete] fdb command to add the first remote VTEP, and then issue this command to add additional remote VTEPs for the same MAC. You cannot add a remote VTEP to a static entry that has ports or blackhole configured. When the last VTEP is deleted, ExtremeXOS deletes the FDB entry for that MAC.
# configure fdb 01:00:5e:00:00:01 vlan vlan101 add vxlan ipaddress 30.30.30.1 # configure fdb broadcast vlan vlan101 add vxlan vr VR-Default ipaddress 30.30.30.1 # configure fdb unknown-unicast vlan vlan101 delete vxlan ipaddress 20.20.20.1
This command was first available in ExtremeXOS 21.1.
This command is supported on the ExtremeSwitching 5320, 5420, 5520, 5720 series switches, and stacks with 5320, 5420, 5520, 5720 slots only.