Enables MLD snooping on the switch.
vlan_name | Specifies a VLAN. |
Disabled.
If a VLAN is specified, MLD snooping is enabled only on that VLAN, otherwise MLD snooping is enabled on all VLANs.
A VLAN must have an IPv6 address to support MLD.
The following command enables MLD snooping on the switch:
enable mld snooping
This command was first available in ExtremeXOS 11.2.
This command is available on the platforms listed for the IPv6 multicast routing feature in the Switch Engine 32.3 Feature License Requirements document.