configure fdb vlan vxlan
configure fdb { mac_addr | broadcast | unknown-unicast | unknown-multicast } vlan vlan_name [ add | delete ] vxlan { vr
vr_name } {ipaddress} remote_ipaddress
Description
This command allows you to add or remove remote VTEPs to a MAC address.
Syntax Description
mac_addr | Forwarding destination(s) for this MAC. |
broadcast | Forwarding destination(s) for broadcast traffic. |
unknown-unicast | Forwarding destination(s) for unknown unicast traffic. |
unknown-multicast | Forwarding destination(s) for unknown multicast traffic. |
add | Add to configuration. |
delete | Delete from configuration. |
vr | VR/VRF instance the IPv4 address is configured on. |
vr_name | An existing VR/VRF name. |
ipaddress | Configure the IP address of the remote tunnel endpoint to which the MAC needs to be bound. |
remote_ipaddress | IPv4 address of the remote tunnel endpoint. |
Default
VR-Default.
Usage Guidelines
You must first use the “[create | delete] fdb” command to add the first remote VTEP, and then issue this command to add additional remote VTEPs for the same MAC. You cannot add a remote VTEP to a static entry that has ports or blackhole configured. When the last VTEP is deleted, ExtremeXOS deletes the FDB entry for that MAC.
Example
configure fdb 01:00:5e:00:00:01 vlan vlan101 add vxlan ipaddress 30.30.30.1 configure fdb broadcast vlan vlan101 add vxlan vr VR-Default ipaddress 30.30.30.1 configure fdb unknown-unicast vlan vlan101 delete vxlan ipaddress 20.20.20.1
History
This command was first available in ExtremeXOS 21.1.