configure radius server client-ip
Description
![Note](../../images/Note_Note.png)
Note
It is recommended to enable loopback mode on the VLAN associated with radius if the radius connectivity is established via a front panel port on a summit stack.Syntax Description
mgmt-access | Specifies the RADIUS authentication server for switch management. |
netlogin | Specifies the RADIUS authentication server for network login. |
primary | Configures the primary RADIUS authentication server. |
secondary | Configures the secondary RADIUS authentication server. |
index | RADIUS server index. Range: 1 - 2147483641. |
ipaddress | The IP address of the server being configured. |
host_ipV6addr | Server IPv6 address. |
hostname | The host name of the server being configured. |
udp_port | The UDP port to use to contact the RADIUS authentication server. |
ipaddress | The IP address used by the switch to identify itself when communicating with the RADIUS authentication server. |
client_ipV6addr | Client IPv6 address. |
vr_name | Specifies the virtual router
on which the client IP is located. Note: User-created VRs are supported only on the platforms listed for
this feature in the Feature License Requirements document.
|
shared-secret | Shared secret |
secret | Secret string. |
encrypted | Password is encrypted. |
Default
- The UDP port setting is 1812.
- The virtual router used is VR-Mgmt, the management virtual router.
- Switch management and network login use the same primary and secondary RADIUS servers for authentication (only if the realm is not specified in the command).,
Usage Guidelines
Use this command to specify RADIUS server information.
Use of the hostname parameter requires that DNS be enabled.
The RADIUS server defined by this command is used for user name authentication and CLI command authentication.
Beginning with ExtremeXOS 11.2, you can specify one pair of RADIUS authentication servers for switch management and another pair for network login. To specify RADIUS authentication servers for switch management (Telnet, SSH, and console sessions), use the mgmt-access keyword. To specify RADIUS authentication servers for network login, use the netlogin keyword. If you do not specify a keyword, switch management and network login use the same pair of RADIUS authentication servers.
If you are running ExtremeXOS 11.1 or earlier and upgrade to ExtremeXOS 11.2, you do not lose your existing RADIUS server configuration. Both switch management and network login use the RADIUS authentication server specified in the older configuration.
Specifying mgmt-access or netlogin before the index will create a RADIUS entry with only that realm specified, if neither are specified both realms will be enabled.
Example
The following example configures the primary RADIUS server on host radius1 using the default UDP port (1812) for use by the RADIUS client on switch 10.10.20.30 using a virtual router interface of VR-Default:
configure radius primary server radius1 client-ip 10.10.20.30 vr vr-Default
The following example configures the primary RADIUS server for network login authentication on host netlog1 using the default UDP port for use by the RADIUS client on switch 10.10.20.31 using, by default, the management virtual router interface:
configure radius netlogin primary server netlog1 client-ip 10.10.20.31
History
This command was first available in ExtremeXOS 10.1.
The mgmt-access and netlogin keywords were added in ExtremeXOS 11.2.
The index, host_ipV6addr, client_ipV6addr, shared-secret, and encrypted keywords were added in ExtremeXOS 16.1.
Platform Availability
This command is available on all platforms.