show inline-power slot
Description
Displays inline power information for the specified node (slot) on SummitStacks.
Syntax Description
slot | Specifies the node (slot). |
Default
N/A.
Usage Guidelines
-
Configured power:
-
Enabled.
-
Disabled.
-
-
System power surplus.
-
Redundant power surplus.
-
Power usage threshold.
-
Disconnect precedence.
-
Legacy—The status of the legacy mode, which allows detection of many non-standard PDs.
-
Inline power status—The status of inline power. The status conditions are:
-
Enabled.
-
Disabled.
-
-
Firmware status—The operational status of the slot. The status conditions are:
-
Operational.
-
Not operational.
-
Disabled.
-
Subsystem failure.
-
Card not present.
-
Slot disabled.
-
-
Budgeted power—The amount of power, in watts, that is available to the slot.
-
Measured power—The amount of power, in watts, that currently being used by the slot.
On a stack, if you do not specify a slot number, the command operates on all active nodes. This command operates only on nodes in the active topology.
Example
The following command displays inline power information for node (slot) 3 on a SummitStack:
show inline-power slot 3
Inline Power System Information Configured : Enabled System Power Surplus : 1500 Watts available for budgeting Redundant Power Surplus : 465 Watts available for budgeting to maintain N+1 Power Usage Threshold : 70 percent (per slot) Disconnect Precedence : lowest-priority Legacy Mode : Disabled Budgeted Measured Slot Inline-Power Firmware Status Power (Watts) Power (Watts) 3 Enabled Operational 50 W 9 W 4 Enabled Card Not Present ( 50 W) n/a 7 Enabled Operational 50 W 0 W Note: A budget value in parentheses is not allocated from the system power
History
This command was first available in ExtremeXOS 11.1.
Platform Availability
It is available on SummitStack when the stack contains Summit family switches listed in Extreme Networks PoE Devices.