configure iproute priority
Description
Changes the priority for all routes from a particular route origin.
Syntax Description
blackhole | Specifies the blackhole route. |
bootp | Specifies BOOTP. |
ebgp | Specifies E-BGP routes. |
host-mobility | Host-Mobility route. |
ibgp | Specifies I-BGP routes. |
icmp | Specifies ICMP. |
isis | Specifies IS-IS and applies only to blackhole routes installed for summary addresses. |
isis-level-1 | Specifies IS-IS Level 1 routing. |
isis-level-1-external | Specifies IS-IS Level 1 External routing. |
isis-level-2 | Specifies IS-IS Level 2 routing. |
isis-level-2-external | Specifies IS-IS Level 2 External routing. |
mpls | Specifies MPLS routing. |
ospf-as-external | Specifies OSPF as External routing. |
ospf-extern1 | Specifies OSPF External 1 routing. |
ospf-extern2 | Specifies OSPF External 2 routing. |
ospf-inter | Specifies OSPFInter routing. |
ospf-intra | Specifies OSPFIntra routing. |
rip | Specifies RIP. |
static | Specifies static routes. |
priority | Specifies a priority number in the range of 11 to 65534. |
vrname | Specifies a VR or VRF name. |
Default
The following table lists the relative priorities assigned to routes depending upon the learned source of the route.
Relative Route Priorities
Route Origin | Priority |
---|---|
Direct | 10 |
MPLS | 20 |
Blackhole | 50 |
Static | 1100 |
HostMobility | 1150 |
ICMP | 1200 |
EBGP | 1700 |
IBGP | 1900 |
OSPFIntra | 2200 |
OSPFInter | 2300 |
IS-IS | 2350 |
IS-IS L1 | 2360 |
IS-IS L2 | 2370 |
RIP | 2400 |
OSPFAsExt | 3100 |
OSPF External 1 | 3200 |
OSPF External 2 | 3300 |
IS-IS L1 Ext | 3400 |
IS-IS L2 Ext |
3500 |
BOOTP | 5000 |
Usage Guidelines
Although these priorities can be changed, do not attempt any manipulation unless you are expertly familiar with the possible consequences. If you change the route priority, you must save the configuration and reboot the system.
![Note](../../images/Note_Note.png)
Note
The priority for a blackhole route cannot overlap with the priority of any other route origin.Example
The following example sets IP route priority for static routing to 1200:
configure iproute priority static 1200
History
This command was first available in ExtremeXOS 10.1.
The route priority restrictions were added in ExtremeXOS 11.1.
The ipv4 keyword was added in ExtremeXOS 11.2.
The vr option was added in ExtremeXOS 12.1.2.
Platform Availability
This command is available on all platforms.