unconfigure ports wan-phy
Description
Resets the configuration parameters of the specified WAN PHY port to default values.
Syntax Description
port_list |
Specifies the port number. On a stand-alone switch, this value is just the port number, and on a modular switch, this value is the slot and port number. |
all |
Specified all WAN PHY ports. |
Default
N/A.
Usage Guidelines
XFP ports must be in WAN PHY mode. To configure the mode, use the configure ports port_list mode {lan | wan-phy} command.
When the all option is used, the command constructs a port_list of all applicable ports—LW-XENPAK ports and/or XFP ports that have been WAN-PHY enabled.
-
Framing—SONET.
-
Clock source—line.
-
Section trace—the IEEE default value, which has no string representation.
-
Path trace—the IEEE default value, which has no string representation.
-
Loopback—off.
Example
The following command unconfigures the configurable WAN PHY OAM parameters on a single LW XENPAK port on a modular switch:
unconfigure ports 2:1 wan-phy
History
This command was available in ExtremeXOS 11.6.
Platform Availability
This command is available on all 10G ports on 10G XFP ports only on the Summit X480 series switches.