Display global information for ERPS (Ethernet Ring Protection Switching).
N/A.
N/A.
Use this command to display global information for ERPS.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB
# show erps
ERPS Enabled: Yes
ERPS Display Config Warnings: On
ERPS Multicast Add Ring Ports: Off
ERPS Multicast Send IGMP Query: On
ERPS Multicast Temporary Flooding: Off
ERPS Multicast Temporary Flooding Duration: 15 sec
Number of ERPS instances: 1
# ERPS ring configuration :
--------------------------------------------------------------------------------
Ring State Type East West Control-Vlan VID
--------------------------------------------------------------------------------
R1 Protection R r 21 +20 cvl (1000)
--------------------------------------------------------------------------------
where State: Init/Idle/Protection/Manual-Switch/Force-Switch/Pending
Type: (I) Interconnected node, (N) RPL Neighbor,
R) RPL Owner, (X) Ring node
Flags: (n) Non-revertive, (r) Revertive,
(+) RPL Protection Port, (^) RPL Neighbor Port
(f) Force Switch Port, (m) Manual Switch Port
This command was first available in ExtremeXOS 15.1.
This command is available on all platforms supported in 12.6 and forward that are running ExtremeXOS.