On a SummitStack use:
install bootrom fname {reboot} {slot slotid}Installs a new version of the ExtremeXOS BootROM image.
| fname | Specifies the BootROM image file. |
| reboot | Reboots the switch after the image is installed. |
| slotid | This parameter is available only on the SummitStack. On a SummitStack, the slotid specifies the node on which the BootROM image should be installed. |
N/A.
When you download a BootROM image, the system asks if you want to install the image immediately after the download is finished. If you choose to install the image at a later time, use this command to install the software on the switch.
The BootROM image file is an .xbr file, and this file contains the executable code.
To display the BootROM version for the switch, use the show version command.
This section provides information about the characters supported by the switch for local and remote filenames.
When specifying a local or remote filename, the switch permits only the following characters:
When naming a local file, remember the requirements listed above.
You can issue this command only from the Master node.
The following example installs the bootrom image file summitX-1.0.1.5-bootrom.xtr:
install bootrom summitX-1.0.1.5-bootrom.xtr
The following messages appear:
Installing bootrom... Writing bootrom... ........................................................................ ........................................................................ ......................... Verifying Flash contents... ........................................................................ ........................................................................ ........................................................................ ........................................................................ .................................................... bootrom written. Bootrom installed successfully
This command was first available in ExtremeXOS 11.0.
From ExtremeXOS 12.0, this command is supported on a stack. The slot parameter is added. The slot parameter is applicable only when the switch is in a stack.
and stacks.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB