show snmpv3 target-addr

show snmpv3 target-addr {[[hex hex_addr_name] | addr_name]}

Description

Displays information about SNMPv3 target addresses.

Syntax Description

hex_addr_name	Specifies an identifier for the target address. The value is to be supplied as a colon separated string of hex octets.
addr_name	Specifies a string identifier for the target address.

Default

N/A.

Usage Guidelines

Use this command to display entries in the SNMPv3 snmpTargetAddressTable. If no target address is specified, the entries for all the target addresses will be displayed.

To view the source IP address, use the show management command.

Example

The following command displays the entry for the target address named A1:

show snmpv3 target-addr A1

The following is sample output from this command:

x670.25 # show snmpv3 target-addr 

Target Addr Name        : v1v2cNotifyTAddr1
TDomain                 : 1.3.6.1.6.1.1
TAddress                : 10.120.91.48, 162
TMask                   :
Timeout                 : 1500
Retry Count             : 3
Tag List                : defaultNotify
Params                  : v1v2cNotifyParam1
Storage Type            : NonVolatile
Row Status              : Active 

Target Addr Name        : v1v2cNotifyTAddr2
TDomain                 : 1.3.6.1.6.1.1
TAddress                : 2001:0:0:0:0:0:0:5, 162
TMask                   :
Timeout                 : 1500
Retry Count             : 3
Tag List                : defaultNotify
Params                  : v1v2cNotifyParam2
Storage Type            : NonVolatile
Row Status              : Active 

Total num. of entries in snmpTargetAddrTable : 2

History

This command was first available in ExtremeXOS 10.1.

This command was modified in ExtremeXOS 11.0 to display a list of tags if more than one was configured and to display the timeout value for the entry in the snmpTargetAddrTable. This command was also modified to support the hex_addr_name parameter.