configure erps timer wait-to-block

configure {erps} ring-name timer wait-to-block [ default | milliseconds]

Description

Configure a wait-to-block timer for revertive operations on RPL owner initiated reversion.

ring-name	Alphanumeric string that identifies the ERPS (Ethernet Ring Protection Switching) ring.
default	The default value, 5500 milliseconds.
milliseconds	The time interval to wait before restoring, with a range of 5000 to 7000 milliseconds.

The default is 5500 milliseconds.

Use this command to configure a wait-to-block timer for revertive operations on RPL owner-initiated reversion.

The following command sets the wait-to-block timer to 6000 milliseconds for an ERPS ring named “ring1”:

configure erps ring1 timer wait-to-block 6000

This command was first available in ExtremeXOS 15.1.

This command is available on all platforms supported in 12.6 and forward that are running ExtremeXOS.

Published September 2018prev | next